HI folks, I finally succumbed to the lure of the improved performance and always on screen of the Huawei Watch to replace my aging Moto 360.
Thanks to all the reviews out there, there have been no surprises. However, with less than 12 hours ownership I was already annoyed with the charging facility. So last night, literally in my pyjamas, I went in the garage and knocked up the following stand.
I used some spare kitchen oak block work surface, and though happy with the overall design and effectiveness of this prototype, I will spend more time over the coming xmas break to make a better version.
Tools used: chop saw, drill with 32mm bit (too small really) and flap wheel and sandpaper.
I used double sided tape to hold the charger in place.
The whole thing took me 10 minutes to make, as I didn't want to spend too much time in case the concept/design wasn't right.
Don't be too critical of craftsmanship or finish, it is only a prototype.
Thanks to all the reviews out there, there have been no surprises. However, with less than 12 hours ownership I was already annoyed with the charging facility. So last night, literally in my pyjamas, I went in the garage and knocked up the following stand.
I used some spare kitchen oak block work surface, and though happy with the overall design and effectiveness of this prototype, I will spend more time over the coming xmas break to make a better version.
Tools used: chop saw, drill with 32mm bit (too small really) and flap wheel and sandpaper.
I used double sided tape to hold the charger in place.
The whole thing took me 10 minutes to make, as I didn't want to spend too much time in case the concept/design wasn't right.
Don't be too critical of craftsmanship or finish, it is only a prototype.
Download from this link
No comments:
Post a Comment